Positioning Jump Rings in Carved Charcoal for Soldering
@umyajewelry carves snug grooves in a soft charcoal block to hold jump rings and bails in place for soldering.
More →
Back
Applying Tension While Soldering Without Binding Wire
A tip from @oneanachronism for holding a gap closed under tension while soldering, an easier alternative to binding wire.
Posted about 7 years ago
•
2,690 likes
•
74 comments
*Please read the comments on this one- Here is a tip for applying tension while soldering from @oneanachronism - “Instead of binding wire here’s an easier way and far less damaging. You can close the gap as tight as possible without the risk of it snapping back.” Thank you so much for sharing this with us 🙌 #metalsmithsociety#jewelrytipoftheday #solderingjewelry
More tips
Honeycomb Board and Pins to Hold a Bail for Soldering
A tip from @shinynotions for pinning a bail in place on a honeycomb soldering board, with pins under the metal to lift it.
More →
Protecting a Stone in a Sand Pot During Ring Resizing
A tip from @vuthejeweller for burying a set stone in a sand pot to protect it from heat while soldering a ring resize.
More →
Sharpie Registration Marks for Fitting Parts
A tip from @moonandforge for drawing Sharpie registration marks on two parts so they line up the same way after each adjustment.
More →