Friction Fit Parts and Pulling Solder Through

Here is an awesome soldering tip from @aimeesutanto - “
One of the few things in the world that give me immediate sense of comfort: friction fit parts. Not only do they just fit tight against each other with zero movement, that also means smooth solder flow. Always place solder from the reverse side whenever possible and 'pull' the solder (using heat) to the opposite side for minimal clean up afterwards. In the case of these prongs, I placed my solder on the backside (bottom left image) and then carefully heated the top (where the prongs are) careful to not melt the prongs.” Thank you sharing this! When you take the time to have two pieces fit together perfectly you make soldering a breeze 🔥🙌 #metalsmithsociety #jewelrycommunity #solderingtips