Back
Sweat Soldering a Stamped Maker's Mark Tag
Learn to stamp your mark on separate sheet, coat it with graphite, then sweat solder it onto your piece so stamping cannot warp it.
Posted over 2 years ago
•
1,740 likes
•
69 comments
Here is a tip if you want to add your makerβs mark but are concerned stamping might be a challenge or warp your piece: β£
β£
ππππ¦π© your custom mark onto 20g sheet .09mm (could be thicker or a bit smaller) and saw out your stamping.β£
β£
ππ©π©π₯π² graphite to your stamping, this will avoid solder flowing into the stamping.β£
β£
ππ°πππ solder it onto your piece. Sweat soldering is when you flow solder on the back of the component (in this case the stamping) place it on your piece and heat from below. β£
β£
In this video I am using the Ti-Quad Soldering Stand from @lionpunchforgeβ£
β£
Adding it this way even adds a bit more dimension to your piece! ππ¨π¦π¦ππ§π if you add your signature to your work and if you have other tips and techniques please share them in the comments!β£
β£
#stampingjewelry #MakersMark #Graphite #solderingtip #SolderingStand #Titanium
β£
ππππ¦π© your custom mark onto 20g sheet .09mm (could be thicker or a bit smaller) and saw out your stamping.β£
β£
ππ©π©π₯π² graphite to your stamping, this will avoid solder flowing into the stamping.β£
β£
ππ°πππ solder it onto your piece. Sweat soldering is when you flow solder on the back of the component (in this case the stamping) place it on your piece and heat from below. β£
β£
In this video I am using the Ti-Quad Soldering Stand from @lionpunchforgeβ£
β£
Adding it this way even adds a bit more dimension to your piece! ππ¨π¦π¦ππ§π if you add your signature to your work and if you have other tips and techniques please share them in the comments!β£
β£
#stampingjewelry #MakersMark #Graphite #solderingtip #SolderingStand #Titanium
