Back

Titanium Soldering Strips as Props for Bails

Learn to saw titanium soldering strips into small pieces to prop up bails and jump rings while soldering.

Posted almost 6 years ago • 2,414 likes • 26 comments

Here is a soldering tip, the @knewconcept titanium soldering strips work great as little lifts for bails and jump rings! I just sawed one into several pieces! They make great props! #soldering #solderingjumprings

More tips

Here is a production tip from @martindenoch -
“I prepare each pin by melting some solder at each end. I then place the...

Soldering Rings onto Pins in Production

A tip from @martindenoch on pre-melting solder on pins, raising rings on a hacksaw blade, and heating the pins so solder pulls the rings in.

Tip for soldering eyelets from @goldschmiede_raspe

“For a nice and clean soldering, ensure that the eyelets are well...

Soldering Eyelets Cleanly With Minimal Solder

A tip from @goldschmiede_raspe on annealing, closing and soldering eyelets with a small amount of solder and controlled heat.

Here is a soldering tip from @Tennessee_Rose_Jewelry - “When I need to solder a jump ring on a delicate chain, I set it...

Soldering a Jump Ring on Delicate Chain

A tip from @Tennessee_Rose_Jewelry for covering delicate chain with a second charcoal block so only the jump ring is exposed.

Here is a soldering tip from @blueberryjewelry02 - “When soldering a clasp and jump ring to the end of a chain, use an...

Heat Sinking a Lobster Clasp When Soldering Chain

A tip from @blueberryjewelry02 for clamping a lobster clasp in locking tweezers as a heat sink so it keeps its spring while you solder.