Back

Community Merch That Supports the Page

A look at the community merch designs and how buying them supports the page.

Posted about 3 years ago • 274 likes • 25 comments

I don’t often post about merch but it is a fantastic way to support Metalsmith Society, I could not continue to do this...

View on Instagram

I don’t often post about merch but it is a fantastic way to support Metalsmith Society, I could not continue to do this without the generous support of our community. Which is your favorite? #jeweler #metalsmithsociety

More tips

Here is a tip if you use prefabricated chains that come with a jumpring that looks a little wonky (top photo) I replace...

Replacing a Wonky Jump Ring on Prefab Chain

Learn to replace and solder a chain's jump ring with heat protectant on the chain, then clean it up safely on a flex shaft.

Here is a brilliant tip to keep patina from getting into certain areas from @drifting_gypsy_designs - “I tried rubber...

Rubber Cement as a Patina Resist

A tip from @drifting_gypsy_designs for painting layers of rubber cement inside a bezel to keep liver of sulfur out, then peeling it off.

Here is a tip for when you have your work on display at a show from @bernattidesigns - “This is so simple I hesitated to...

Plastic Wrapping Jewelry Displays for Show Setup

A tip from @bernattidesigns for wrapping fully loaded jewelry displays in plastic wrap so setup at shows goes faster.

Here is a #diy file handle from @artifactprocess - “I’ve been doing a lot of filing lately and I realized my files get...

DIY Cork File Handles

A tip from @artifactprocess for drilling a pilot hole in craft corks to make comfortable, inexpensive file handles.