Burring a Depression in a Bench Pin for Filing
A tip from @mklahn for cutting a small depression in a bench pin with a hart bur to support work while filing its edge.
More →Curated from @metalsmithsociety on Instagram and searchable by keyword or hashtag.
A tip from @mklahn for cutting a small depression in a bench pin with a hart bur to support work while filing its edge.
More →
A tip from @everthine_jewelry for stamping straight words using a marker line, an electrical tape guide and starting from the middle letter.
More →
Learn to draw graphite pencil on areas where you do not want solder to flow, shown on a textured ring shank.
More →
Learn to make a quick prong setting from 19g sterling wire, trimmed with @lindstromtools shear cutters and shaped with a Moore's disc.
More →
A tip from @willowandtwigg: lay jump ring joins just over the block edge to avoid flat spots, using paste solder.
More →
Learn to fit a heart bezel by shaping the upper cusp first with pliers, using annealed wire and a toothbrush bezel pusher.
More →
A tip shared by @janet.wise and @pyrus_designs: hold small, hard to grip pieces with an eraser while sanding.
More →
Learn to run a 2/0 saw blade through a ring seam that is not flush so the ends close tightly before soldering.
More →
A tip from @lucywalkerjewellery: color the seat with Sharpie to see where the stone touches and cut until it no longer rocks.
More →
A tip from @laaracerman for backing sandpaper strips with duct tape for strength and writing the grit on the back for use in a saw.
More →
A tip from @waxcarvers for sticking stones to wax with beeswax to trace around them before carving a stone seat.
More →
My annual holiday gift guide for jewelry makers is live on the blog, alongside studio setup and refining guides.
More →